May also be viewed on YouTube, Vimeo, and Facebook. But, best right here where you are. Remember! The annual Christmas Ornament Challenge happens during November!. A local club asked me to demonstrate turning a bottle stopper. But, I cannot make myself make a plain one when I can dress it up by turning it on […]
Read More...May also be viewed on YouTube. This bud vase is spalted birch harvested about a year ago. It is an eccentric turning on four axes: Main and offset by 3/8 inch at 120 degree intervals. A year ago, I rough turned it round and waxed it. It has been laying around my shop since then. […]
Read More...Also may be viewed on YouTube. This wood came from a fig tree in my front yard. It’s a small limb but had to go. I’ve never turned fig nor heard of anyone turning it. But why not try. Although it’s small, it is large enough for a simple tea light. I did not […]
Read More...After last week’s egg cup, Larry joked “why not an eccentric egg cup”. I took that as a challenge. This triple egg cup is turned from red cedar and finished with beeswax and mineral oil. The turning axis was shifted 1.25″ in three directions 120 degrees apart to turn the hollows for the eggs. It […]
Read More...A little bit ago, I made a simple handle for a 4-in-1 (actually 6-in-1 but I never use the hex driver). At the time, I noted that eccentric techniques could prevent the screwdriver from rolling easily. Here’s the upgrade. I shifted the turning axis 0.25 inch in opposite directions to turn two opposing flatter curves. […]
Read More...A viewer suggesting making a leather burnisher. I was excited at the suggestion as it is another idea to exercise the eccentric faceplate system. Many would leave the blade as a cone or flatten it on a sander. To me, however, it was an opportunity to take the eccentric faceplate system for a spin. This […]
Read More...In this video, I’m going into greater detail on the faceplates and system used in making the doubly eccentric magic wand. The system consists of 2 faceplates, 4 brass pins, and some plastic countertop laminate. With the system, I can exactly index most eccentric spindle turnings that use a tail stock. Although I made these […]
Read More...In this video, I’m going another step beyond in eccentric turning. Building on a viewer suggestion to use masking tape to enable power transmission while backing off the pressure between tailstock and headstock. I made a pair of threaded faceplates in which I drilled holes to provide regular offsets. Corresponding holes would then be drilled […]
Read More...After the last video, I decided to go one step further and make an eccentric blade for another wand. By using multiple axes, the blade will be crooked, a special twist to please any wizard. This full sized 17″ long wand is made from walnut and red oak. It is finished with mineral oil and […]
Read More...I am interested in multi-axis and off center turning. However, any change to the turning axis presents challenges and risks. This project, from hard maple, follows an example in “Woodturning Methods” by Mike Darlow. On the first axis, I turned the body, foot, and a mounting disk. Then I mounted a wood faceplate with a […]
Read More...